- Wire Wreath Form
- Dollar Tree Fall Towel
- Hot Glue Gun & Glue Sticks
- Fabric Scraps
- Brown Wire
- Small Pinecone
I was excited to incorporate this Dollar Tree towel into a fall wreath! First I used a pen to trace where I wanted to cut the towel. I made sure to leave room for the towel to be wrapped around the inner ring.
Then I cut the towel out. I turned the towel and wreath form over so I could glue the towel to the wreath form. I put hot glue on the edge of the towel and wrapped it around the inner ring of the wreath.
Once all edges of the towel were glued to the inner ring, I started cutting strips of burlap to wrap around the other rings. I used a piece of burlap that was starting to unravel a bit and wanted it to have a more rustic look. I wrapped the strips around the rest of rings on the wreath. I used hot glue to secure the burlap at the beginning and the end of the wrapping.
I wanted to make a fabric bow to put on the wreath. I already had some fabric strips cut so I gathered those so that there were loops on both ends of the bow. Once I had all that I wanted I used a small piece of brown wire to secure the bow in the middle. and fluffed the bow to get how I wanted it to look. I added a small pinecone in the middle of the bow.
Then I used hot glue to attach the bow to the wreath.
This is a super simple wreath and you could customize it with your favorite towel, burlap, and fabric!! Comment below if you give this a try!
Here are other blog posts to check out with wreath tutorials!